Print 3D

Edit:03 janv. 2018, Cre:21 juil. 2015


Video Fisher Delta printing filament PETG, temperature 275°C (a bit too much), layer height 0.2mm, width 0.4mm
Perimeters 150 mm/s, infill 190 mm/s acceleration 5000mm/sec2.
Note that while acceleration is significant, the max speed is only attained on a few segments because this is a relatively small part. Full sustained speed can only be shown in vase mode on relatively large vase to allow sufficient cooling time between layers.

Film size : 11.5 Mb

(c) Pierre ROUZEAU
Éditer - Historique - Imprimable - Changements récents - Rechercher
Page mise à jour le 03/01/2018 00:50